Snapper 9260 :  Bluewater Systems Support Forum

Announcements		Last Post
	Linux 2.6.29	07/01/2009 10:07PM
	Welcome to the Bluewater Support Forums	01/27/2009 03:12PM

Subject	Views	Posts	Started By	Last Post
I2C Voltage Level Problem: < 2.0V	156	18	pteh	05/06/2010 09:36PM  Last Post by andre
U-boot flash partitions	205	3	Stephen	03/17/2010 09:35PM  Last Post by Stephen
initialize SD card after boot - sort of hot plug	279	3	IGW	03/12/2010 07:09PM  Last Post by IGW
MAC Address unique for all Snapper 9260 modules?	220	2	pteh	03/02/2010 05:52PM  Last Post by Ryan
Details on audio clock output	665	15	IGW	02/11/2010 04:00PM  Last Post by IGW
ethernet termination	463	4	Glenn	09/10/2009 02:33AM  Last Post by andre
telnetd fails to allow incoming connections	627	3	robin szemeti	09/07/2009 04:46PM  Last Post by rszemeti
Mount of USB disk fails	498	3	pas	08/31/2009 09:32AM  Last Post by pas
boot fails	494	2	Lance	08/28/2009 01:34PM  Last Post by andre
NANDRNB use?	494	2	pteh	08/24/2009 02:31PM  Last Post by Ryan
3V3_OK_N which GPIO?	466	2	pteh	08/23/2009 09:57PM  Last Post by Ryan
Need Pull-Up Resistors for I2C interface?	495	4	pteh	08/17/2009 01:01AM  Last Post by andre
How to load U-Boot when there is no U-Boot?	485	2	pteh	08/11/2009 05:09PM  Last Post by Ryan
MCLK	557	2	IGW	08/10/2009 10:44PM  Last Post by Ryan
how to use host port	594	2	lajmi	06/08/2009 09:05PM  Last Post by andre
ipkg Segmentation Fault	804	6	tom	06/05/2009 08:15PM  Last Post by andre
OpenEmbedded machine file	753	3	tom	06/01/2009 04:02PM  Last Post by tom
Snapper9260 and Quickstart Kit initial boot	760	15	tom	05/19/2009 04:24PM  Last Post by tom
Polarity indication to power on the Snapper 9260 QS Kit	761	2	fab	04/23/2009 03:49PM  Last Post by andre